How to use the Firewood Cutter in My Winter Car

The Firewood Cutter, aka the Lumber Conveyor, is an exceptional tool if you’re looking to sell and cut Firewood in My Winter Car.

This item can’t be used on its own, and you’ll need to use the tractor to do so. However, the job is easier said than done, and this guide will help you become a woodcutter in a few simple steps.

How to use the Lumber Conveyor in My Winter Car

The first task is to connect the Cutter to the Kekmet. It’s impossible to move the Lumber Conveyor from its stationary position without attaching it to your tractor. Hence, drive the tractor carefully and place it very close to the Conveyor. Keep the distance to a minimum; otherwise, the alignment will be loose and logs will fall.

Image via Amistech Games

You’ll find the rear hitch lever on the right side of the Kekmet. Use it to lower the attachment arms from the rear of the tractor. Get down, and click the connection point on the cutter (once the attachment arms have been lowered). If aligned properly, the cutter will connect with the Kekmet.

Next, use the PTO lever located to the left of the steering wheel. Activate it to start the sdrive shaft and the Conveyor. If you want the cutter to work fast, go for a higher RPM, but this will shorten your session.

How to cut the Firewood in My Winter Car

Image via Amistech Games

Once you have completed all the steps mentioned earlier in the guide, take a log from the wood pile. Then, place it in the cutter slot. It will automatically split the logs into pieces based on RPM. The Conveyor will automatically place the Firewood in the trailer (don’t forget to attach it).

Destructoid is supported by our audience. When you purchase through links on our site, we may earn a small affiliate commission. Learn more about our Affiliate Policy